![]() Use the setting menu to turn WWVB OFF and set the correct hourĮither way your clock will resume normal WWVB functions Jan 1st with the DST ON setting.Then in January use the setting menu to turn DST ON and resume normal use. – or the clock will correct the hour overnight with the next WWVB reception. Use the setting menu to select DST OFF then set the hour back one hour.There are two easy ways to immediately correct the hour. Your clock will automatically correct itself Jan 1st. Note: If your clock advances one hour in December it is due to a leap second adjustment that was programmed incorrectly. When the Atomic time signal is received, the clock will set to the time zone selected. Press and release SET to search for the WWVB time signal.After reception, this clock will only search for the atomic signal after midnight.If there is no WWVB reception, the clock will search for the atomic time signal every 2 hours until the WWVB time is received.Once batteries are installed, the clock will automatically search for the atomic time signal at UTC 7:00, 8:00, 9:00, 10:00, and 11:00.After 5 minutes place sensor in a shaded outdoor location.Insert 2-AA batteries into the TX141-Bv2 sensor according to polarity. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |